Vertical Flow Fills - PLASdek® / BIOdek®

High operation reliability
Limits the accumulation of solids and thick biofilms
Optimum solids discharge
Due to vertical channnels and open interfaces
Self supporting structure
High bearing capacity with variable sheet thicknesses
High resistance to erosion
Provided by double folded edges or reinforced PP edges
Low pressure drop
Due to vertical direction of all channels
Long service life
Due to chemical, bacterial and UV resistance of PP and PVC

Here you will find
information about
our
cross-fluted fills

Product overview Vertical Flow Fills FC33

Product overview Vertical Flow Fills KVP und KGP

This information has been put together with greatest care. However, any performance data given on this page is subject to compliance with certain surrounding conditions and hence may vary from case to case. Further, we reserve the right to make changes at any time without notice. We strongly recommend (i) reconfirmation with GEA 2H whether this information is still fully valid, before using it for final designs and (ii) to verify performance data taking into account the actual surrounding conditions. GEA 2H takes no responsibility for any consequences due to non-compliance with these recommendations.