Nozzles - SPN Series

Optimum water distribution
Full cone nozzle with maximum spray angle of 120°
Low clogging and scaling tendency
Due to smooth surface design
Constant self cleaning
By high turbulence in the nozzle body
Easy installation onto the piping system
Due to BSP thread and hexagon body design
High resistance to a large range of chemicals
Nozzles are made of glass reinforced polyamide (nylon)

Product overview Nozzles - SPN

Flow Diagram

Flow Diagram Nozzles - SPN

General Remarks

Axial nozzle is designed as complete cone spiral nozzle which consists of a casing and an insert.
After correct assembly the nozzle distributes the water with a spray angle of 120°.
The water flow rate depends on the operational pressure.
The arrangement in the plant, i.e. nozzle distance and height, is dependent on the respective plant design.

This information has been put together with greatest care. However, any performance data given on this page is subject to compliance with certain surrounding conditions and hence may vary from case to case. Further, we reserve the right to make changes at any time without notice. We strongly recommend (i) reconfirmation with GEA 2H whether this information is still fully valid, before using it for final designs and (ii) to verify performance data taking into account the actual surrounding conditions. GEA 2H takes no responsibility for any consequences due to non-compliance with these recommendations.